setupguide:setup_with_prolineadmin_gui
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
setupguide:setup_with_prolineadmin_gui [2016/06/13 11:19] 193.48.0.3 [Set up the Datastore] |
setupguide:setup_with_prolineadmin_gui [2016/07/07 14:09] (current) 132.168.72.225 [Set up the Datastore] |
||
|---|---|---|---|
| Line 46: | Line 46: | ||
| === Configure the mount-points === | === Configure the mount-points === | ||
| - | Note that the section named //Mount points// is enable only if the Proline server configuration file has been located. | + | Note that the section named //Mount points// is enable only if the Proline server configuration file has been located (see screenshot above). |
| Input files (e.g. *.RAW, *.WIFF, *.D) should be set in the 'Raw files' sub-section.\\ | Input files (e.g. *.RAW, *.WIFF, *.D) should be set in the 'Raw files' sub-section.\\ | ||
| Line 67: | Line 67: | ||
| ==== Set up the Datastore ==== | ==== Set up the Datastore ==== | ||
| - | Once the configuration files has been edited and validated, the button //Set up Proline datastore// becomes availbale in the main page. Click it to finish the Datastore setup. | + | Once the configuration files has been edited and validated, the button //Set up Proline datastore// becomes availale in the main page. Click it to finish the Datastore setup. |
| __Note__: This functionality will be disabled if Proline is already set up or if Proline configuration is invalid. | __Note__: This functionality will be disabled if Proline is already set up or if Proline configuration is invalid. | ||
setupguide/setup_with_prolineadmin_gui.1465809577.txt.gz · Last modified: 2016/06/13 11:19 by 193.48.0.3
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
