userguide:umctomsidb
This is an old revision of the document!
Table of Contents
Mode details about importing UMCs to MSIdb
Transfering Viper result folder(s) into MSI database:
- Establish a gateway between the MSI database (PostgreSQL) and the AMT database (MS Access)
- For each Viper result folder:
- Check Viper folder contents
- Read (and optionaly filter) UMCs file
- Write QuantiContext to MSI database
AMTdb / MSIdb gateway
Requirements:
- Open the MSI session corresponding to the one used to generate the AMT database. This MSI session must contain the UserContext used to
- AMT database file (.mdb)
Viper result folder transfer
userguide/umctomsidb.1331799582.txt.gz · Last modified: 2012/03/15 09:19 by 132.168.73.124
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
